Commands In The Ddns Client Configuration Mode; Service - Siemens SCALANCE S615 Configuration Manual

Syntax
Call the command without parameter assignment:
no shutdown
Result
The setting is enabled.
Further notes
You disable the setting with the
6.5.5

Commands in the DDNS Client configuration mode

This section describes commands that you can call up in the DDNS CLIENT configuration
mode.
In the Global configuration mode, enter the
● If you exit the DDNS CLIENT configuration mode with the
the Global configuration mode.
● If you exit the DDNS CLIENT configuration mode with the
Privileged EXEC mode.
6.5.5.1

service

Description
With this command, you enable the dynamic DNS provider.
Requirement
You are in the DDNS Client configuration mode.
The command prompt is as follows:
cli(config-ddnsclient)#
Syntax
Call up the command with the following parameters:
service {show-services | <index>}
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
shutdown
ddnsclient
Network protocols
command to change to this mode.
command, you return to
exit
command, you return to the
end
6.5 DNS
217