Configuration
2.1 System
Result
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder
Type of interface
vlan
fastethernet
The placeholders
The ranges of values from the physical interfaces depend on the hardware configuration.
Further notes
You exit the Interface configuration mode with the
You delete a logical interface with the
You display the status and the configuration of the interfaces with the
command.
2.1.9.5
no interface
Description
With this command, you delete a logical interface.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no interface{vlan<vlan-id(1-4094)>}
The parameters have the following meaning:
Parameter
vlan
vlan-id
54
is replaced by the following name of the interface:
$$$
Command prompt
cli(config-if-vlan-$)#
cli(config-if-F-X)#
and
stand for the numbering of the interface.
$
X
no interface
Description
Keyword for a VLAN connection
Number of the addressed VLAN
or
command.
end
exit
command.
show interfaces
Values
-
1 ... 4094
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02