Srv Name Addr - Siemens SCALANCE S615 Configuration Manual

Network protocols
6.9 Proxy server
6.9.3.3

srv name addr

Description
With this command, you change the address of the proxy server.
Requirement
● The proxy server name has been created.
● You are in the PROXYSERVER configuration mode.
The command prompt is as follows:
cli(config-proxysrv)#
Syntax
Call up the command with the following parameters:
srv name <string(128)> addr <ip_addr|dns(50)>
The parameters have the following meaning:
Parameter
string
ip_addr
dns
Result
The IPv4 address of the proxy server has been changed.
Further notes
You display the available proxy server names with the
You create the proxy server with the
260
Description
Proxy server name
IPv4 address
DNS host name
srv name
Range of values / note
Specify the proxy server
name.
Maximum of 128 characters
Enter the IPv4 address of the
proxy server.
Enter the DNS host name of
the proxy server.
Maximum of 50 characters
srv show-names
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.