Commands In The Loadsave Configuration Mode; Delete - Siemens SCALANCE S615 Configuration Manual

Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
loadsave
Result
You are now in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Further notes
You exit the LOADSAVE configuration mode with the
2.2.5

Commands in the LOADSAVE configuration mode

This section describes commands that you can call up in the LOADSAVE configuration
mode.
In the Global Configuration mode, enter the
You display the valid file types for the commands in the LOADSAVE Configuration mode
with the global command
● If you exit the LOADSAVE configuration mode with the
Global Configuration mode.
● If you exit the LOADSAVE configuration mode with the
Privileged EXEC mode.
2.2.5.1

delete

Description
With this command, you call up the possible files or delete a specific file.
Requirement
You are in the LOADSAVE configuration mode.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
loadsave
.
show loadsave tftp
2.2 Load and Save
command.
exit
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Configuration
73