Ip Echo-Reply - Siemens SCALANCE S615 Configuration Manual

The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no dcp server
Result
The DCP server is disabled.
Further notes
You enable and configure the DCP server with the
6.1.2.3

ip echo-reply

Description
To check the availability of a network node, packets of the Internet Control Message Protocol
(ICMP) can be sent to it. These packets of type 8 request the recipient to send a packet back
to the sender (echo reply).
With this command you enable the network node to react to ping queries.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip echo-reply
Result
"ICMP echo reply messages" are enabled. The network node reacts to ping queries.
Further notes
You disable the setting with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
dcp server
command.
no ip echo-reply
Network protocols
6.1 IPv4 protocol
command.
177