Security and authentication
9.3 IPsec VPN
Syntax
Call the command without parameter assignment:
vir-ip
Result
The setting is enabled.
Further notes
You display this setting and other information with the
You disable the requesting of a virtual IPv4 address with the
9.3.5.9
no vir-ip
Description
With this command, you disable the requesting of a virtual IPv4 address.
Requirement
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(onfig-conn-X)#
Syntax
Call the command without parameter assignment:
no vir-ip
Result
The setting is disabled.
Further notes
You display this setting and other information with the
You enable the requesting of a virtual IPv4 address with the
378
show ipsec connections
no vir-ip
show ipsec connections
command.
vir-ip
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
command.
command.