No Remote-End Name; No Remote-End All - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
Security and authentication
9.3 IPsec VPN
9.3.3.7
no remote-end name
Description
With this command, you delete a specific VPN remote station.
Requirement
● The corresponding VPN remote station has been created and is not being used
anywhere.
● You are in the IPSEC REMOTE END configuration mode.
cli(config-ipsec-rmend-X)#
Syntax
Call up the command with the following parameters:
no remote-end name <name(128)>
The parameter has the following meaning:
Parameter
name
Result
The corresponding VPN remote station is deleted.
Further notes
You create the VPN remote station with the
9.3.3.8
no remote-end all
Description
With this command, you delete all VPN remote stations.
364
The command prompt is as follows:
Description
Name of the VPN remote station
Range of values / note
Enter the name of the VPN re-
mote station.
command.
remote-end name
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Hide quick links:
Advertisement
Table of Contents
