Ipv4Rule Set Prior; Ipv4Rule Set Service - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.2 Firewall
9.2.4.15

ipv4rule set prior

Description
With this command, you change the priority of the IPv4 firewall rule.
Requirement
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
ipv4rule idx <number(1-100)> set prior <number(0-64)>
The parameters have the following meaning:
Parameter
idx
number
prior
integer
Result
The priority of the corresponding IPv4 firewall rule has been changed.
Further notes
You display this setting and other information with the
command.
You obtain the numbers with the
9.2.4.16

ipv4rule set service

Description
With this command, you change the service or protocol name.
328
Description
Keyword for index
Number corresponding to a spe-
cific IPv4 rule.
Keyword for the priority
Priority
ipv4rule show-rules
Range of values / note
-
Enter the required number.
1 ... 100
-
Enter the priority for the IPv4 rule.
0 ... 64
show firewall ip-rules ipv4
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02