Autofwnat - Siemens SCALANCE S615 Configuration Manual

Functions specific to SCALANCE
3.5 SINEMA RC
3.5.4.2

autofwnat

Note
This command is only available with a KEY-PLUG.
Description
With this command, you enable the automatic creation of the firewall and NAT rules for the
connection to the SINEMA RC Server.
Requirement
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call the command without parameter assignment:
autofwnat
Result
The automatic firewall and NAT rules are created. The connections between the configured
exported subnets and the subnets that can be reached via the SINEMA RC Server are
allowed. The NAT settings are implemented as configured in the SINEMA RC Server.
Further notes
You enable the setting with the
You disable the setting with the
112
command.
autofwnat
command.
no autofwnat
Configuration Manual, 06/2015, C79000-G8976-C406-02
SCALANCE S615 Command Line Interface