No Snmp Targetaddr; Snmp Targetparams - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
6.6.2.15
no snmp targetaddr
Description
With this command, you delete the SNMP target address.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp targetaddr <TargetAddressName>
The parameter has the following meaning:
Parameter
TargetAddressName
Result
The SNMP target address is deleted.
Further notes
You change the SNMP target address with the
You display the SNMP target address with the
6.6.2.16
snmp targetparams
Description
With this command, you configure the SNMP target parameters.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
SNMP target address
show snmp targetaddr
Range of values / note
max. 32 characters
command.
snmp targetaddr
command.
Network protocols
6.6 SNMP
243
Hide quick links:
Advertisement
Table of Contents
