Configure Terminal - Siemens SCALANCE S615 Configuration Manual

Configuration
2.1 System
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If no parameters are specified, the counters for all interfaces are reset.
Result
The counters of the interface are reset.
Further notes
You can display the statistical information of the interfaces with the
counters
2.1.3

configure terminal

Description
With this command, you change to the Global configuration mode.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameters:
configure terminal
Result
You are now in the Global configuration mode.
The command prompt is as follows:
cli(config)#
46
Description
Type or speed of the interface
Module no. and port no. of the interface
command.
Range of values / note
Specify a valid interface.
show interfaces -
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02