Commands In The Cert Configuration Mode; Show-Idx - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.4 Certificates
9.4.2

Commands in the CERT configuration mode

This section describes commands that you can call up in the CERT configuration mode.
In the Global configuration mode, enter the
● If you exit the CERT configuration mode with the
configuration mode.
● If you exit the CERT configuration mode with the
Privileged EXEC mode.
9.4.2.1

show-idx

Description
The command lists the loaded certificates and their indexes.
Requirement
● Certificates are loaded.
● You are in the CERT configuration mode.
The command prompt is as follows:
cli(config-cert)#
Syntax
Call the command without parameter assignment:
show idx
Result
The list is displayed.
408
command to change to this mode.
certificate
command, you return to the Global
exit
command, you return to the
end
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02