Verification Cacert - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
3.5.4.11
verification cacert
Note
This command is only available with a KEY-PLUG.
Description
With this command, you specify the CA certificate of the server used to sign the server
certificate.
Requirement
● The certificate is loaded.
● You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call up the command with the following parameters:
verification cacert [<name(256)>]
The parameter has the following meaning:
Parameter
name
Result
The CA certificate of the server is configured.
Further notes
You load certificates with the
You display this setting and other information with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Name of the server certificate
command.
tftp load
Functions specific to SCALANCE
3.5 SINEMA RC
Range of values / note
Enter the name of the server
certificate.
Maximum of 256 characters.
command.
show sinemarc
121
Hide quick links:
Advertisement
Table of Contents
