Diagnostics
10.1 Event and fault handling
Result
The settings for monitoring the physical network connections have been configured.
Further notes
You can display the current setting with the
You disable the function with the
10.1.10.7
no link
Description
With this command, you disable the monitoring of the physical network connections for cable
breaks or for pulling of the connector.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no link {up|down}
The parameters have the following meaning:
Parameters
up
down
Result
The settings for monitoring the physical network connections have been configured.
Further notes
You can display the current setting with the
You enable the function with the
430
no link
Description
The message when establishing a connection is
disabled
The message when a connection is down is disa-
bled
command.
link
show events faults config
command.
show events faults config
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
Range of values
-
-
command.