No Ip Dhcp-Server Pool - Siemens SCALANCE S615 Configuration Manual

Simatic net industrial ethernet security command line interface
Hide thumbs Also See for SCALANCE S615:
Table of Contents

Advertisement

Network protocols
6.4 DHCP server
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp-server pool { <pool-id (1-5)> | show-interface-options }
The parameters have the following meaning:
Parameter
pool-id
show-interface-options
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The ID of the addressed IPv4 address band is configured.
You are now in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Further notes
You exit the DHCPPOOL configuration mode with the
You delete the entry with the
6.4.2.6

no ip dhcp-server pool

Description
With this command, you delete the required IPv4 address band.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
196
Description
ID of the addressed IPv4 address band
Displays the possible options for the interface. -
no ip dhcp-server pool
Configuration Manual, 06/2015, C79000-G8976-C406-02
Range of values / note
1 ... 5
command.
exit
command.
SCALANCE S615 Command Line Interface

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents