No Snmp Group - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
Network protocols
6.6 SNMP
Parameter
security-model
Storage type
If optional parameters are not specified when configuring a group, the default values apply.
Result
The details of the group are configured.
Further notes
You delete the details of an SNMP group with the
You display the created SNMP groups with the
You display the created SNMP user with the
6.6.2.11
no snmp group
Description
With this command, you delete the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp group <GroupName> user <UserName>security-model{v1|v2c|v3}
238
Description
specifies which security settings will be
used
specifies whether the settings remain
following a restart
show snmp user
Range of values / note
•
v1
•
v2c
•
v3
•
volatile
The settings are lost after a
restart
•
nonvolatile
The settings are retained after
a restart
command.
no snmp group
command.
show snmp group
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
(volatile):
(non-volatile):
Hide quick links:
Advertisement
Table of Contents
