No Interface Range - Siemens SCALANCE S615 Configuration Manual

5.1.2.3

no interface range

Description
With this command, you remove the interfaces or interfaces of VLANs from the interface
range or break it up if you first remove all previously added interfaces.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no interface range vlan <vlan-id(1-4094)> - <vlan-id(2-4094)>
The parameters have the following meaning:
Parameter
vlan
vlan-id
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you address several VLANs, you must insert a blank before and after the hyphen, for
example
Result
The VLANs have been removed from the specified interface area.
Further notes
With the
able to configure them together.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Number of the addressed VLAN
no interface range vlan 5 - 10
command, you can put several interfaces or VLANs together to be
interface range
Range of values / note
-
1 ... 4094
2 ... 4094
.
Network structures
5.1 VLAN
147