Service Name Set Src - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.2 Firewall
Further notes
You display the available service names with the
You create the service with the
You display this setting and other information with the
command.
9.2.4.41

service name set src

Description
With this command, you change the source port.
Requirement
● The service name has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
service name <string(32)> set src {all| port <number(0-65535)>| range <number(0-
65535)> - <number(0-65535)>}
The parameters have the following meaning:
Parameter
string
all
Port
number
range
number
number
Result
The source port of the corresponding service has been changed.
352
service name
Description
Service name
Applies to all ports.
Keyword for a port
Port number
Keyword for a port range
Start port
End port
service show-names
command.
show firewall ip-services
Range of values / note
Specify a valid service name.
Maximum of 32 characters
-
-
0 ... 65535
Specify the required port.
-
0 ... 65535
Specify the start port and end port, e.g.
10 - 20
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.