Link - Siemens SCALANCE S615 Configuration Manual

Parameter
trap
faults
digital-out
vpn-tunnel
all
Result
The setting deciding which messages of the device are not stored or forwarded is
configured.
Further notes
You display the status of the events and the clients with the
You configure which of the various message types of the device will be stored or forwarded
with the
10.1.10.6

link

Description
With this command, you configure and enable the monitoring of the physical network
connections for cable breaks or for pulling of the connector.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
link {up|down}
The parameters have the following meaning:
Parameters
up
down
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Client that sends the SNMP traps
Error LED lights up. The setting is possible only for a cold or warm restart.
Controls the digital output or signals the status change with the "DO" LED.
Controls the VPN connection (establishment/termination).
All clients at once
command.
event config
Description
Only the establishment of a connection is signaled
Only a break on a connection is signaled
Diagnostics
10.1 Event and fault handling
command.
show events config
Range of values
-
-
429