No Src-Nat All - Siemens SCALANCE S615 Configuration Manual

Layer 3 functions
8.1 NAT
Syntax
Call up the command with the following parameters:
no src-nat srcint <if-type> [<num(0-4094)>] dstint <if-type(50)> [<num(0-4094)>] idx
<num(1-200)>
The parameters have the following meaning:
Parameter
srcint
if-type
num
dstint
if-type
num
idx
num
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The specified source NAT rule is deleted.
Further notes
You delete all source NAT rules with the
You create a source NAT rule with the
You display the numbers of the source NAT rules with the
8.1.3.13

no src-nat all

Description
With this command, you delete all source NAT rules.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
300
Description
Keyword for the source interface
Type or speed of the interface
Number of the addressed interface
Keyword for the destination interface
Type or speed of the interface
Number of the addressed interface
Keyword for the number of the source NAT rule
Number corresponding to a specific source NAT
rule.
no src-nat all
src-nat type ipv4
Range of values / note
-
Specify a valid interface.
0 ... 4094
-
Specify a valid interface.
0 ... 4094
-
Specify a valid number.
0 ... 200
command.
. command.
src-nat show-idx
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.