Snmp; The "Show" Commands; Show Snmp - Siemens SCALANCE S615 Configuration Manual

Network protocols

6.6 SNMP

6.6 SNMP
This section describes commands of the Simple Network Management Protocol (SNMP).
6.6.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
6.6.1.1

show snmp

Description
This command shows the status information of SNMP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show snmp
Result
The status information is displayed.
222
do [command]
[command]
or
cli#
you can execute the "show" commands in every
with the "show" command that you want to execute.
Configuration Manual, 06/2015, C79000-G8976-C406-02
SCALANCE S615 Command Line Interface