Map Subnet - Siemens SCALANCE S615 Configuration Manual

5.1.3.1

map subnet

Description
With this command, you configure the subnet assignment to a VLAN.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
map subnet <ip-subnet-address> vlan <vlan-id(1-4094)>
<mask> [arp {suppress | allow}]
The parameters have the following meaning:
Parameter
ip-subnet-address
vlan
vlan-id
mask
arp
suppress
allow
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The subnet with subnet mask and subnet address is assigned to a VLAN.
Further notes
You cancel the setting with the
You can display the status of this function and other information with the
mapping
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
IP subnet address
Keyword for a VLAN connection
Number of the addressed VLAN
Subnet mask
Keyword ARP protocol
Suppress the ARP protocol
Allow the ARP protocol
command.
command.
no map subnet
Network structures
5.1 VLAN
Range of values / note
Enter a valid subnet address.
-
1 ... 4094
aaa.bbb.ccc.ddd
-
-
-
show subnet-vlan
155