Static-Lease Mac - Siemens SCALANCE S615 Configuration Manual

6.4.3.9

static-lease mac

Description
With this command you specify that devices with a certain MAC address are assigned to the
selected IPv4 address.
Note
A maximum of 20 assignments are possible.
Requirement
● The assignment has not yet been created.
● You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
static lease mac <mac-address><ip-address>
The parameters have the following meaning:
Parameter
mac-address
ip-address
Result
The assignment is specified.
Further notes
You display the setting with the
You disable the IPv4 address band with the
You delete the assignment with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Unicast MAC address
Unicast IPv4 address
show ip dhcp dhcp-server bindings
no pool-enable
no static-lease mac
Network protocols
6.4 DHCP server
Range of values / note
Specify the MAC address.
aa:bb:cc:dd:ee:ff
Enter a valid IPv4 address.
The IPv4 address must match
the subnet of the IPv4 address
band.
command.
command.
command.
205