Prerule Dns Ipv4 - Siemens SCALANCE S615 Configuration Manual

Result
The predefined firewall rule DHCP is enabled on the relevant interface. The DHCP server or
the DHCP client can be accessed via the interface.
Further notes
You display this setting and other information with the
command.
You list the available interfaces with the
See also
Commands in the FIREWALL configuration mode (Page 313)
9.2.4.24

prerule dns ipv4

Description
With this command, you enable the predefined firewall rule DNS on the selected interface.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
prerule dhcp ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Parameter
int
interface-type
num
all-int
enabled
disabled
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
prerule ipv4 show-int
Description
Keyword for the interface
Type or speed of the interface
Interface index
Enables the predefined firewall rule on all inter-
faces.
Enables the predefined firewall rule.
Disables the predefined firewall rule.
Security and authentication
show firewall pre-rules ipv4
command.
Range of values / note
-
Specify a valid interface.
Specify a valid interface
index.
0 ... 10
-
-
-
9.2 Firewall
335