No Netmap - Siemens SCALANCE S615 Configuration Manual

netmap destination srcint <if-type> [<num(0-4094)>] dstint <if-type> [<num(0-4094)>]
type ipv4
srcip <subnet> dstip <subnet> transip <subnet>
The parameters have the following meaning:
Parameter
srcint
if-type
num
dstint
if-type
num
srcip
subnet
dstip
subnet
transip
subnet
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The NETMAP rule for the address translation of the destination IP address has been
created. During creation, an entry with a unique number (index) is created.
Further notes
You delete a NETMAP rule with the
You delete all NETMAP rules with the
You display the numbers of the NETMAP rules with the
You display the NETMAP rule with the
8.1.3.8

no netmap

Description
With this command, you delete a specific NETMAP rule.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Keyword for the source interface
Type or speed of the interface
Number of the addressed interface
Keyword for the destination interface
Type or speed of the interface
Number of the addressed interface
Keyword for the source subnet.
The subnet can also be a single PC or another
subset of the subnet.
Keyword for the destination subnet
The subnet can also be a single PC or another
subset of the subnet.
Keyword for the subnet with which the destina-
tion subnet is replaced.
The subnet can also be a single PC or another
subset of the subnet.
no netmap
no netmap all
show firewallnat netmap-nat
Range of values / note
-
Specify a valid interface.
0 ... 4094
-
Specify a valid interface.
0 ... 4094
Specify the subnet in the
CIDR notation.
-
Specify the subnet in the
CIDR notation.
-
Specify the subnet in the
CIDR notation.
command.
command.
netmap show-idx
command.
Layer 3 functions
8.1 NAT
command.
295