Sntp Client Addressing-Mode - Siemens SCALANCE S615 Configuration Manual

4.3.6.4

sntp client addressing-mode

Description
With this command, you configure the addressing mode of the SNTP client as unicast or
broadcast.
Requirement
● The SNTP client is activated.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp client addressing-mode{unicast|broadcast}
The parameters have the following meaning:
Parameter
unicast
broadcast
Result
The addressing mode of the SNTP client is configured.
Further notes
You display this setting and other information with the
You display the settings for the unicast mode with the
command.
You display the settings for the broadcast mode with the
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
configures the SNTP client in unicast
mode
configures the SNTP client in broad-
cast mode
Range of values / note
Default: unicast enabled
-
command.
show sntp status
show sntp unicast-mode status
show sntp broadcast-mode status
System time
4.3 SNTP client
137