The parameters have the following meaning:
Parameter
string
type
integer
code
integer
Result
The ICMP packet type and code have been changed.
Further notes
You display the available service names with the
You show the available ICMP packet types and codes with the
command.
You delete this service with the
You display this setting and other information with the
command.
9.2.4.4
icmp show-names
Description
With this command, you display the available ICMP service names.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call the command without parameter assignment:
icmp show-names
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
ICMP service name
Keyword for the ICMP packet type
Number corresponding to a specific
ICMP packet type.
Keyword for the code of the ICMP
packet type
Number corresponding to a specific
code.
command.
no icmp
Security and authentication
Range of values / note
Specify a valid service name.
Maximum of 255 characters
-
Enter the required number.
-
Enter the required number.
The selection depends on the ICMP
packet type.
command.
icmp show-names
icmp show-types-codes
show firewall icmp-services ipv4
9.2 Firewall
317