No Map Subnet - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
Network structures
5.1 VLAN
5.1.3.2
no map subnet
Description
With this command, you remove a subnet from a VLAN.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no map subnet <ip-subnet-address>
The parameters have the following meaning:
Parameter
ip-subnet-address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The subnet with subnet mask and subnet address is assigned to a VLAN.
Further notes
You configure the setting with the
You can display the status of this function and other information with the
mapping
156
Description
IP subnet address
command.
command.
map subnet
Configuration Manual, 06/2015, C79000-G8976-C406-02
Range of values / note
Enter a valid subnet address
show subnet-vlan
SCALANCE S615 Command Line Interface
Hide quick links:
Advertisement
Table of Contents
