Commands In The Global Configuration Mode; Loadsave - Siemens SCALANCE S615 Configuration Manual

Configuration
2.2 Load and Save
The parameters have the following meaning:
Parameter
filetype
filetype
tftp
ipv4
ipv4-address
port
tcp port
file
filename
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The file is saved on the TFTP server.
Further notes
With the "
2.2.4

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
2.2.4.1

loadsave

Description
With this command, you change to the LOADSAVE configuration mode.
72
Description
Keyword for a file type to be loaded
Name of the file type
Keyword for a TFTP server
Keyword for an IPv4 address
Value for an IPv4 unicast address
Keyword for the port of the server via
which the TFTP connection runs
Number of the port
Keyword for a file name to be assigned -
Name of the file
" command, you can display the file types.
show loadsave files
command to change to this mode.
configure terminal
or
end exit
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Range of values / note
-
max. 100 characters
-
-
Enter a valid IPv4 unicast ad-
dress.
-
1 ... 65535
Default: 69
max. 100 characters
command and are then in the