Configuration
2.4 Configuration Save & Restore
2.4.3.2
no auto-save
Description
With this command, you disable the auto save function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no auto-save
Result
The auto save function is disabled. The Trial mode is activated.
Further notes
You enable the function with the
You can display the status of this function and other information with the
information
You save changes to the configuration in the Trial mode with the
command.
86
auto-save
command.
command.
write startupconfig
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
show device