Addr-Mode - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.3 IPsec VPN
9.3.4.2

addr-mode

Description
With this command, you specify the type of the remote station address.
Requirement
You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call up the command with the following parameters:
addr-mode <manual|any>
The parameters have the following meaning:
Parameter
manual
any
Result
The setting is specified.
Further notes
You configure the mode with the
You configure the IP address with the
368
Description
Accepts the connection from remote
stations with a specific address.
Accepts the connection from remote
stations with any IPv4 address.
command.
conn-mode
command.
addr
Range of values / note
In Roadwarrior mode
•
Only accepts connections
from remote stations with a
fixed IP address (/32),
fixed IP subnet (CIDR nota-
tion), or (D)DNS host name.
In standard mode
•
Only establishes a connection
to a specific remote station
with a fixed IP address
or with (D)DNS host name.
Or only accepts a connection
from a specific remote station
with a fixed IP address or with
(D)DNS host name.
Only in Roadwarrior mode
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02