Further notes
You display this setting and other information with the
command.
You enable an entry with the
6.5.5.3
userhost
Description
With this command, you configure the host name that you have agreed with your dynamic
DDNS provider for the device, e.g. example.no-ip.com.
Requirement
You are in the DDNS Client configuration mode.
The command prompt is as follows:
cli(config-ddnsclient)#
Syntax
Call up the command with the following parameters:
userhost {show-services | <index> <host>}
The parameters have the following meaning:
Parameter
show-services
index
host
Result
The host name is configured.
Further notes
You display this setting and other information with the
command.
You configure the user name with the
You configure the password with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
no service
Description
Lists the available providers.
Number corresponding to a specific
provider.
Host name
username
command.
password
show ddnsclient information
Range of values / note
-
Specify a valid number.
Specify the agreed host name.
show ddnsclient information
command.
Network protocols
6.5 DNS
219