Commands In The Ipsec Connection Configuration Mode; Authentication; K-Proto - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.3 IPsec VPN
9.3.5

Commands in the IPSEC CONNECTION configuration mode

This section describes commands that you can call up in the IPSEC CONNECTION
configuration mode.
In the IPSEC configuration mode, enter the
● If you exit the IPSEC CONNECTION configuration mode with the
return to the IPSEC configuration mode.
● If you exit the IPSEC CONNECTION configuration mode with the
return to the Privileged EXEC mode.
9.3.5.1

authentication

Description
With this command, you change to the IPSEC AUTHENTICATION configuration mode.
Requirement
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(config-conn-X)#
Syntax
Call the command without parameter assignment:
authentication
Result
You are now in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
Further notes
You exit the IPSEC AUTHENTICATION configuration mode with the
9.3.5.2

k-proto

Description
With this command, you specify whether IKEv2 or IKEv1 will be used.
372
command to change to this mode.
connection
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command, you
exit
command, you
end
or command.
end exit