Verification Fingerprint - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
Functions specific to SCALANCE
3.5 SINEMA RC
3.5.4.12
verification fingerprint
Note
This command is only available with a KEY-PLUG.
Description
With this command, you configure the fingerprint of the device. The fingerprint is assigned
during commissioning of the SINEMA RC Server. You will find further information on this in
the Operating Instructions of the SINEMA RC Server.
Requirement
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call up the command with the following parameters:
verification fingerprint <string(59)>
The parameter has the following meaning:
Parameter
string
Result
The fingerprint is configured. Based on the fingerprint, the device checks whether the correct
SINEMA RC Server is involved.
Further notes
You display this setting and other information with the
122
Description
Fingerprint of the device
Range of values / note
Specify the fingerprint of the
device.
Maximum of 59 characters
command.
show sinemarc
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Hide quick links:
Advertisement
Table of Contents
