Ntp; Commands In The Ntp Configuration Mode; Ntp Server - Siemens SCALANCE S615 Configuration Manual

4.2.2.1

ntp

Description
With this command, you change to the Network Time Protocol (NTP).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ntp
Result
You are now in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Further notes
You exit the NTP configuration mode with the
4.2.3

Commands in the NTP configuration mode

This section describes commands that you can call up in the NTP configuration mode.
In the Global configuration mode, enter the
● If you exit the NTP configuration mode with the
configuration mode.
● If you exit the NTP configuration mode with the
EXEC mode.
4.2.3.1

ntp server

Description
With this command, you configure the connection to a server on the NTP client.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
or command.
end exit
command to change to this mode.
ntp
command, you return to the Global
exit
command, you return to the Privileged
end
System time
4.2 NTP client
127