Manual Srv; No Manual Srv - Siemens SCALANCE S615 Configuration Manual

6.5.3.1

manual srv

Description
With this command, you specify a manually configured DNS server. A maximum of three
DNS servers can be configured.
Requirement
You are in the DNS CLIENT configuration mode.
The command prompt is as follows:
cli(config-dnsclient)#
Syntax
Call up the command with the following parameters:
manual srv <ip_addr>
The parameter has the following meaning:
Parameter
ip_addr
Result
The DNS server is configured.
Further notes
You display this setting and other information with the
command.
You configure the DNS server type with the
You delete the DNS server with the
See also
Interface identifiers and addresses (Page 25)
6.5.3.2

no manual srv

Description
With this command, you delete a specific DNS server or all DNS servers.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
IPv4 address
server type
command.
manual
Network protocols
Range of values / note
Enter a valid IPv4 address.
show dnsclient informationen
command.
6.5 DNS
211