Dynamic Mac Aging; Show Commands; Show Mac-Address-Table Aging-Time - Siemens SCALANCE S615 Configuration Manual

Load control

7.2 Dynamic MAC aging

7.2 Dynamic MAC aging
The section describes commands with which the aging of dynamically learned entries is
configured in a MAC address list.
7.2.1

show commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
7.2.1.1

show mac-address-table aging-time

Description
To ensure that the address entries are up-to-date, MAC addresses are only kept in the
address table for a specified time.
This command shows the time after which the MAC addresses are removed from the
address table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show mac-address-table aging-time
Result
The time is displayed.
280
do [command]
[command]
or
cli#
you can execute the "show" commands in every
with the "show" command that you want to execute.
Configuration Manual, 06/2015, C79000-G8976-C406-02
SCALANCE S615 Command Line Interface