Logon Idx Addr - Siemens SCALANCE S615 Configuration Manual

Result
The specified destination server entry is deleted.
Further notes
You create a destination server entry with the
You display the numbers of the destination servers with the
3.4.3.5

logon idx addr

Note
This command is only available with a KEY-PLUG.
Description
With this command, you change address of a specific destination server.
Requirement
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Syntax
Call up the command with the following parameters:
logon idx <num(1-100)> addr <ip_addr|dns(50)>
The parameters have the following meaning:
Parameter
num
ip_addr
dns
Result
The address of the destination server has been changed.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
logon addr
Description
Number corresponding to a specific
destination server.
IPv4 address
DNS host name
Functions specific to SCALANCE
command.
command.
logon show-idx
Range of values / note
Enter the required number.
Enter the IPv4 address of the
proxy server.
Enter the DNS host name of the
proxy server.
Maximum of 50 characters
3.4 SRS
103