Diagnostics; Event And Fault Handling; The "Show" Commands - Siemens SCALANCE S615 Configuration Manual

Diagnostics

The monitoring of the system and error diagnostics are handled in different ways:
● Event and fault handling:
Predefined events generate a message. These messages can be distributed in different
ways:
– Entry in local logs
– Transfer to the Syslog server
– Sending as SNMP trap
– Lighting up of the error LED
– Switching at the digital output
● Syslog client:
Configures the transfer to the Syslog server
10.1

Event and fault handling

In events and faults handling, you set the events whose messages will be distributed in one
of the available ways.
You configure the monitoring of certain system events and power supply and physical
interfaces in the Events configuration mode.
10.1.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
you can execute the "show" commands in every
do [command]
with the "show" command that you want to execute.
[command]
10
411