10.1.1.6
show fwlog
Description
With this command, you show the messages that occurred in the firewall. The messages can
be filtered according to the event severity.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show fwlog [{ info | warning | critical }]
Parameter
The parameters have the following meaning:
Parameter
info
warning
critical
If you use the command without setting parameters, all messages are displayed.
Result
The content of the firewall log is displayed.
10.1.1.7
show logbook
Description
With this command, you display the content of the logbook.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
or
cli#
Description
Information
Warnings
Critical messages
or
cli#
Diagnostics
10.1 Event and fault handling
Range of values / note
-
-
-
415