Prerule All Ipv4 - Siemens SCALANCE S615 Configuration Manual

cli(config-fw)#
Syntax
Call the command without parameter assignment:
prerule ipv4 show-int
Result
The interfaces are listed.
9.2.4.22

prerule all ipv4

Description
With this command, you enable all predefined firewall rules on the selected interface.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
prerule all ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Parameter
int
interface-type
num
all-int
enabled
disabled
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode (Page 313)".
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Keyword for the interface
Type or speed of the interface
Interface index
Enables all predefined firewall rules on all inter-
faces.
Enables the predefined firewall rules.
Disables the predefined firewall rules.
Security and authentication
9.2 Firewall
Range of values / note
-
Specify a valid interface.
Specify a valid interface
index.
0 ... 10
-
-
-
333