Ddnsclient; Commands In The Dns Client Configuration Mode - Siemens SCALANCE S615 Configuration Manual

Network protocols
6.5 DNS
6.5.2.4

ddnsclient

Description
With this command, you change to the DDNS Client configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ddnsclient
Result
You are now in the DDNS Client configuration mode.
The command prompt is as follows:
cli(config-ddnsclient)#
Further notes
You exit the DDNS Client configuration mode with the
6.5.3

Commands in the DNS CLIENT configuration mode

This section describes commands that you can call up in the DNS CLIENT configuration
mode.
In the Global configuration mode, enter the
● If you exit the DNS CLIENT configuration mode with the
Global configuration mode.
● If you exit the DNS CLIENT configuration mode with the
Privileged EXEC mode.
210
or command.
end exit
command to change to this mode.
dnsclient
command, you return to the
exit
command, you return to the
end
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02