Prerule Ip Ipv4 - Siemens SCALANCE S615 Configuration Manual

Simatic net industrial ethernet security command line interface
Hide thumbs Also See for SCALANCE S615:
Table of Contents

Advertisement

Security and authentication
9.2 Firewall
Parameter
num
all-int
enabled
disabled
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode".
Result
The predefined firewall rule HTTPS is enabled on the relevant interface. The WBM can be
accessed using HTTPS.
Further notes
You display this setting and other information with the
command.
You list the available interfaces with the
See also
Commands in the FIREWALL configuration mode (Page 313)
9.2.4.27

prerule ip ipv4

Description
With this command, you enable the predefined firewall rule for IPv4 services on the selected
interface.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
prerule ip ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
338
Description
Interface index
Enables the predefined firewall rule on all inter-
faces.
Enables the predefined firewall rule.
Disables the predefined firewall rule.
prerule ipv4 show-int
Range of values / note
Specify a valid interface
index.
0 ... 10
-
-
-
show firewall pre-rules ipv4
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents