Ipv4Rule Set Log - Siemens SCALANCE S615 Configuration Manual

9.2.4.14

ipv4rule set log

Description
With this command, you change the making of entries in the firewall log.
Requirement
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
ipv4rule idx <number(1-100)> set log {no|info|war|cri}
The parameters have the following meaning:
Parameter
idx
number
integer
log
none
info
war
cri
Result
Entering in the firewall log has been changed.
Further notes
You display this setting and other information with the
command.
You obtain the numbers with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Keyword for index
Number corresponding to a spe-
cific IPv4 rule.
Number of the interface
Keyword for making entries in the
firewall log
The rule coming into effect is not
logged.
Messages about event severity
" " are logged.
information
Messages about event severity
" " are logged.
warning
Messages about event severity
" " are logged.
critical
ipv4rule show-rules
Security and authentication
Range of values / note
-
Enter the required number.
1 ... 100
0 ... 4094
-
-
-
-
-
show firewall ip-rules ipv4
command.
9.2 Firewall
327