Show Dcp Forwarding; Show Dcp Server - Siemens SCALANCE S615 Configuration Manual

Network protocols
6.1 IPv4 protocol
6.1.1.2

show dcp forwarding

Description
This command shows an overview of the DCP forwarding behavior on one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show dcp forwarding [port<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The overview of the DCP forwarding behavior is displayed.
6.1.1.3

show dcp server

Description
This command shows whether or not the DCP function is enabled on the device.
If the DCP function is enabled, the read and write permissions are displayed.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
172
or
cli#
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
or
cli#
Range of values / note
-
Enter a valid interface.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02