Mac-Address-Table Aging-Time - Siemens SCALANCE S615 Configuration Manual

7.2.2.3

mac-address-table aging-time

Description
With this command, you configure the aging of a dynamically learned entry in the MAC
address list.
Note
Addresses with light data traffic
For addresses with low data traffic, it is recommended to enter a higher value for the aging.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table aging-time <seconds(10-1000000)>
The parameter has the following meaning:
Parameter
seconds
At system start or when using the
following defaults apply:
● The default value is 300 seconds.
Result
The value of the aging of a dynamically learned entry is configured.
Further notes
You can reset the setting to the default with the
You display the setting with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Life of the entry in seconds
restart
show mac-address-table aging-time
command with the option
no mac-address-table aging-time
Load control
7.2 Dynamic MAC aging
Range of values
10 ... 1000000
or , the
memory factory
command.
command.
283