Network Structures; Vlan; The "Show" Commands; Show Subnet-Vlan Mapping - Siemens SCALANCE S615 Configuration Manual

Network structures

5.1

VLAN

This section describes commands for configuring and managing virtual networks (VLANs).
5.1.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
5.1.1.1

show subnet-vlan mapping

Description
This command shows the subnets for the selected interface or for all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show subnet-vlan mapping
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
do [command]
[command]
or
cli#
[{interface<interface-type><interface-id>}]
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
you can execute the "show" commands in every
with the "show" command that you want to execute.
Range of values / note
-
Specify a valid interface.
5
139