Commands In The Global Configuration Mode; Srs - Siemens SCALANCE S615 Configuration Manual

Functions specific to SCALANCE

3.4 SRS

3.4.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
3.4.2.1 srs
Note
This command is only available with a KEY-PLUG.
Description
With this command, you change to the SRS configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
srs
Result
You are now in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Further notes
You exit the SRS configuration mode with the
98
command to change to this mode.
configure terminal
or
end exit
or command.
end exit
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command and are then in the