Tftp Server - Siemens SCALANCE S615 Configuration Manual

Simatic net industrial ethernet security command line interface
Hide thumbs Also See for SCALANCE S615:
Table of Contents

Advertisement

2.2.5.5

tftp server

Description
With this command, you configure the access to a TFTP server.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp server ipv4 <ipv4-address>[port<tcp port(1-65535)>]
The parameters have the following meaning:
Parameter
ipv4
ipv4-address
port
tcp port
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The settings for the access to the selected TFTP server are configured.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Keyword for an IPv4 address
Value for an IPv4 unicast address
Keyword for the port of the server via
which the TFTP connection runs
Number of the port
Configuration
2.2 Load and Save
Range of values / note
-
Enter a valid IPv4 unicast ad-
dress.
-
1 ... 65535
77

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents