Port - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.3 IPsec VPN
9.3.8.11

port

Description
With this command, you specify the port via which the VPN tunnel communicates.
Requirement
● The VPN connection region is assigned a VPN remote station.
● You are in the IPSEC PHASE configuration mode.
Syntax
Call up the command with the following parameters:
port {all|<integer(0-65535)> [- <integer(0-65535)>]}
The parameters have the following meaning:
Parameter
all
integer
integer
Result
The port is configured.
Further notes
You display this setting and other information with the
You assign a VPN remote station to the VPN connection with the
406
The command prompt is as follows:
cli(config-conn-phs2)#
Description
Applies to all ports.
Port or port range
Range of values / note
-
Specify the port.
Specify the port range with start port "-"end port, e.g. 30 - 40.
show ipsec conn-phase2
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
command.
rmend name